RIO IN AND OUT PENDANT

This product is made to order and will be shipped within 12-16 weeks of purchase.
By KAIA

‘Ring it on‘

This ring light pendant consists of a large solid brass ring embedded with LED lights on both sides. This halo-like circle of even light is suspended from a network of three brass stems, which converge into one and meet the ceiling at a fixed point. The resulting pendant appears to hover effortlessly in mid-air, casting sculptural shadows onto the ceiling.

The RIO collection is based on the mesmeric properties of a nimbus – the white rings that appear around the moon when light refracts through ice crystals in the atmosphere. 

‘Like this mesmerising natural phenomenon, I wanted RIO to be enlightening and uplifting.’ – Peter Straka, the KAIA designer behind the RIO collection, among others. 


Designed by Peter Straka
Handmade by KAIA


DOWNLOADS

PRODUCT SPECIFICATIONS

Dimensions:

1100 mm x 34 mm x 47 mm (43.3 in x 1.33 in x 1.85 in)

Weight:

10.5 g (23.14 lb)

MATERIALS & FINISHES

RIO IN AND OUT PENDANT is made from Solid brass and available in the following finishes:

030 08 202 - Brushed brass

This product can be offered with dim to warm technology on request. Please contact sales@kaialighting.com

DELIVERY & RETURNS

For ‘off-the-shelf’ Goods purchased through Our Site, the Goods will normally be delivered within one – four weeks after the date of payment receipt unless otherwise agreed or specified during the ordering process.

For ‘customised line’ Goods purchased through Our Site, the Goods will normally be delivered within eight – fourteen weeks after the date of payment receipt unless otherwise agreed or specified during the ordering process.

For more information, please refer to our trade B2B and retail B2C Terms and Conditions.

MOUNTING INSTRUCTIONS

Before commencing installation, ensure the relevant mains supply has been safely isolated/disconnected.

Installation shall be carried out by a qualified electrician only. Ensure all electrical connections are tight with no loose strands, including factory made connections. The mains power must only be switched on once the fitting has been electrically connected to the driver.

1. Fix the base plate to the mounting surface using 4 No. 4mm screws. Ensure the fixing points can support the weight of the fixture.
2. Feed the cables through the stem.
3. Tighten the stem firmly onto the top ball.
4. Feed the cables and the stem through the ceiling rose top.
5. Tighten the stem firmly onto the base plate. Connect the unit to the mains.
Please refer to the Dimmer Unit installation manual if you connect the fitting to the dimming system.
6. Lastly, fix the ceiling rose with the knurled screw. Tighten slightly!

CARE INSTRUCTIONS & PATINATION